If you cut dovetails by hand, a Moxon vise is one of the best upgrades you can make to your bench. Here's what it is, how to use one, and how to pick the right size.
What is a Moxon vise?
A Moxon vise is a twin-screw vise that sits on top of your workbench instead of hanging off the front of it. It's named after Joseph Moxon, who described a similar double-screw vise in his 17th-century book Mechanick Exercises.
It has two jaws and two screws. The rear jaw clamps to your bench, and the front jaw moves in and out on the screws. Your board stands up between the jaws, held tight along its whole width.
Why use one?
- Better sawing height. It raises the work several inches above the bench top, so you can saw dovetails standing upright with a clear view of your line. Your back will notice the difference.
- Holds wide boards. Because the screws are spread apart, a wide board passes between them and gets clamped evenly across its width. A single-screw face vise tends to rack when you clamp something off to one side.
- Works on any bench. It clamps to the front edge of your bench, so you can add one without rebuilding anything. No bench yet? It works on a sturdy kitchen or picnic table too.
- Comes off when you don't need it. Clamp it on for joinery, then set it aside and have your whole bench back.
How to use a Moxon vise
- Clamp it down. Set the vise on your bench with the front jaw's lip against the front edge, then hold it down with two clamps or holdfasts on the rear jaw.
- Load the board. Open the jaws, drop the board in end-up, and set the height so the part you're sawing sits just above the jaws. Less board sticking up means less chatter.
- Snug both screws. Tighten them evenly. On my vises the screw holes in the front jaw are oblong, so the jaw can angle slightly to clamp tapered work.
- Saw. Mark and cut your tails or pins. For a long run of dovetails, back off one screw, slide the next board in and re-tighten.
Tip: some woodworkers line the jaws with thin cork or leather for extra grip and to protect finished surfaces.
Standard or Lite?
My Moxon vise comes in two sizes. Both are solid hard maple and open to 4-1/4" between the jaws.
| Standard | Lite | |
|---|---|---|
| Width between the screws | 24" | 14" |
| Screw diameter | 1-3/4" | 1-1/8" |
| Weight | About 16 lb | About 7-1/2 lb |
| Best for | Carcass and wide panel dovetails | Drawer dovetails; easy to carry and store |
If you build casework, chests or anything with wide dovetailed panels, get the Standard. If you mostly cut drawer joinery, work in a small shop, or want something you can carry to a class, the Lite is the better fit.
Finishing and care
Use a penetrating oil and skip film finishes like lacquer, shellac or water-based poly. Wax the screw threads with a silicone-free paste wax so they spin freely, and re-wax whenever they start to drag.
Common questions
Do I need a Moxon vise if I have a leg vise? Not strictly, but most people who own both reach for the Moxon for dovetails. It holds wide boards without racking and puts the work at a better height for sawing.
Can I use it on a table instead of a workbench? Yes. Any sturdy table you can clamp to will work.
How wide a board will it hold? Up to 24" between the screws on the Standard and 14" on the Lite.
Every vise I make comes with 30-day returns and a lifetime warranty.
Or compare all my vises on the Vise Selection Chart.
Nick Dombrowski, toolmaker